Investment casting and design models made of plastic

3D printing with plastic is the ideal solution for cost-effective and time-saving production of investment casting and design models. The models are produced by applying a particulate material in layers and selectively bonding it with a binder. PMMA (polymethyl methacrylate), an acrylic plastic, is used as the particulate material.

Properties of plastic

  • Ideal for producing investment casting models, thanks to the optimum burnout properties of the PMMA particulate material
  • Can also be used as prototypes, design patterns, museum exhibits or film props
  • High print resolution and detail accuracy
  • Economical production in batch sizes of 1 as well as in small series production

 
Benefits of 3D-printing plastic models:

  • Economical production: investment casting models are printed "without tools" and without producing complex and expensive models
  • Large-format printing: Molds can be produced on a building platform measuring 1,000 x 600 x 500 mm (LxWxH)
  • Complex components: Nearly unlimited geometries.
  • True-to-detail models due to a layer thickness of 150 µm and a print resolution of up to 600 dpi
  • High size accuracy: No danger of heat distortion - even in large 3D models - due to a printing process that takes place at room temperature
  • Ideal investment casting handling due to wax infiltration just like conventional wax models
  • Low residual ash content
  • No shell breakage due to negative thermal expansion coefficients
  • Surface finishing: wax infiltration for smoother investment-cast parts or epoxy resin to increase strength in display models

 

Contact us and order your component here

PLASTIC
Base materialPMMA particle material (55 µm)PMMA particle material (85 µm)
Binder-typePolyPor BPolyPor C 
Tensile strengthup to 4.3 MPaup to 3.7 MPa
Yield point1 %1 %
Burn-out temperature700 °C600 °C
Residual ash content< 0.3 weight %< 0.02 weight %
Especially suited forInvestment casting; design modelsInvestment casting
Advantagessharp edges; for highest accuracy and true-to-detail; reusable particle materialburns out very well
TECHNICAL DATAPLASTIC PARTS
Layer thickness     Standard 150 µm
Resolution x, yup to 600 dpi
Accuracy± 0,4 % (min. ± layer thickness)
SUITABLE FINISHING TREATMENTWaxEpoxy
Tensile strengthsee base materialup to 25 MPa
Softening temp.73 °C 80 °C
Burn-out temp.see base material   -
Characteristicssmooth liquid, resistant surfacesolid material, dyeable